SCC110015060R SmartSolar MPPT 100/15 Victron Energy

The wireless solution to set-up, monitor and update the controller using Apple and Android smartphones, tablets or other devices.

For a wired data connection to a Color Control panel, PC or other devices

Especially in case of a clouded sky, when light intensity is changing continuously, an ultra-fast MPPT controller will improve

energy harvest by up to 30% compared to PWM charge controllers and by up to 10% compared to slower MPPT controllers.

Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect

the load when the battery has been discharged to a pre-set voltage.

Alternatively, an intelligent battery management algorithm can be chosen: see Battery Life.

The load output is short circuit proof.

When a solar charge controller is not able to recharge the battery to its full capacity within one day, the result is often that

the battery will continually be cycled between a ‘partially charged’ state and the ‘end of discharge’ state. This mode of

operation (no regular full recharge) will destroy a lead-acid battery within weeks or months.

The Battery Life algorithm will monitor the state of charge of the battery and, if needed, day by day slightly increase the load

disconnect level (i.e. disconnect the load earlier) until the harvested solar energy is sufficient to recharge the battery to nearly

the full 100%. From that point onwards the load disconnect level will be modulated so that a nearly 100% recharge is

achieved about once every week.

See the software section on our website for details

See the software section on our website for details